STEP 2. ELECTRICAL HOOK-UP
Caution
Professional techniques need to used when making any electrical connection. A qualified electrician should perform these procedures.
Be sure to follow all standard safety procedures for installing electrical devices.
Do not disassemble or alter the configuration of the motor or the unit's electrical connections. This may cause injury to you or damage to the product.
The electrical connection should be made only to the type of power source indicated on the marking label.
The motor requires standard AC input (unless an alternate voltage has been specified). All connections are made to the electrical box on the side of the unit (audience left).
There are several switch controls available. Follow the installation procedure for the type of switch control you will install.
General suggestions for wiring:
Soldering is recommended.
The use of wire nuts is acceptable.
Refer to Figure 3 for an illustration of the electrical connection on the side of the screen unit.
Romex
Connector
Screen
Electrical
Connection
Figure 3: Electrical connection
Visionary Electriscreen: Owner’s Manual | 5 |
