Stiga PRO 25 Areas Of Use, Starting And Operation, Filling with petrol, Engine casing 7U, Work

ENGLISH

3.Release the control lever (1:S) to lock the seat. The seat is equipped with a safety switch that is connected to the machine’s safety system. This means that certain dangerous activities are not pos- sible when there is nobody sitting on the seat. Also see 4.3.2.

2.4.18 Engine casing (7:U)

In order to access the fuel cock, battery and engine, the machine has an engine casing that can be opened. The engine cas- ing is locked with a rubber strap.

The engine casing is opened as follows:

1.Undo the rubber strap (7:V) at the front edge of the casing.

2.Carefully lift the engine casing back.

Close in the reverse order.

The machine may not be operated un- less the engine casing is closed and locked. Risk of burns and crushing in- juries.

2.4.19Quick-release mounting (34:H)

The quick-release mountings allow the deck to be moved easily between the two positions:

•Normal position with fully tensioned belt.

•4 cm behind the normal position with slackened belt.

As the belt idler is released from the belt, the quick-release mountings simplify belt and deck re- placement, and also make shifting to the washing position and service positions easier.

Releasing the belt tension:

1.Remove the locking pins (34:G) from both sides.

2.Press down the rear section of the quick-release mountings (34:F) with the lug.

3.Carry out necessary corrective action, e.g. set- ting the deck to the washing position.

Tensioning the belt:

First tension one side and then the other according to the instructions below.

Use protective gloves when handling the lever. Risk of crushing injuries.

3 AREAS OF USE

The machine may only be used for the following tasks using the genuine STIGA accessories stated.

Work	Accessories, STIGA genuine
Mowing	Using mowing decks:
	95C, 95C El, 105C, 105C El,
	121 M, 121 M El, 110 Combi
	Pro, 110 Combi Pro El, 125
	Combi Pro, 125 Combi Pro El
	and with flail mower.
Sweeping	Using brush unit or collector
	brush unit. The use of a dust
	guard is recommended with the
	first option.
Snow clearance	Using snow blade or snow
	thrower Snow chains are recom-
	mended.
Grass clipping and	Using towed collector 30" or
leaf collection	42".
Grass and leaf	Using dump cart Standard, Maxi
transport	or Combi.
Sand spreading	Using sand spreader. Can also
	be used for spreading salt. Snow
	chains are recommended.
Weeding on gravel	Using front-mounted hoe.
paths
Lawn edge trim-	Using edge trimmer.
ming
Moss scarification	Using moss scarifier.

The maximum vertical load on the towing hitch must not exceed 100 N.

The maximum over-run load on the towing hitch from towed accessories must not exceed 500 N. NOTE! Before using a trailer – contact your insur- ance company.

NOTE! This machine is not intended to be driven on public roads.

4 STARTING AND OPERATION

The machine may not be operated un- less the engine casing is closed and locked. Risk of burns and crushing in- juries.

1.Firmly grasp the lever (35:J) in front of the cen- tre of the shaft and carefully turn 180° forwards.

2.Install the locking pin (34:G).

3.Carry out the above on the other side.

4.1Filling with petrol

Always use lead-free petrol. You must never use 2- stroke petrol mixed with oil.

The tank holds 14 litres. The level can easily be read through the transparent tank.

NOTE! Ordinary lead-free petrol is a perishable and must not be stored for more than 30 days.

67