ENENGLISH
2.4.9 Ignition lock/headlight (4,5:I)
The ignition lock is used for starting and stopping the engine. The ignition lock is also the switch for the headlight.
Do not leave the machine with the key in position 2 or 3. There is a fire risk, fuel can run into the engine through the carburettor, and there is a risk of the battery being discharged and damaged.
Four positions:
1.Stop position – the engine is
2.Operating position – headlight activat- ed.
3.Operating position – headlight not acti- vated.
4.Start position – the electric start motor is activated when the key is turned to the
Turn the key to position 2 to light the headlight.
2.4.10Power take-off (4,5:K)
Switch for engaging/disengaging the electromag- netic power
1.Press the front part of the switch – the power
2.Press the rear part of the switch – the power
2.4.11Hour meter (2:P)
Indicates the number of working hours. Only works when the engine is running.
2.4.12 Cruise control (5, 6:N)
A switch for activating the cruise control. The cruise control locks the pedal (3:F) in the desired position.
1.Press down the pedal (3:F) until the de- sired speed is obtained. Then press the front part of the switch to activate the cruise control. The symbol will light up.
2.Disengage the cruise control by releas- ing it with the pedal (3:B) or pressing the rear part of the switch.
2.4.13 Cutting height adjustment (4,5:J)
The machine is equipped with a control for using the cutting deck with electrical cutting height ad- justment.
The switch is used to adjust the cutting height in continuously variable positions.
The cutting deck is connected to the contact (2:Q).
2.4.14Rear Rake (5:L)
(Pro20, Pro25, Pro Svan)
The machine is fitted with a control for electrical adjustment of a rear rake (available as an accessory).
The switch is used to raise and lower the rear rake.
Cables for connecting the rear rake are found at the rear of the machine, to the left of the upper side of the bumper.
2.4.15Sand spreader (6:O) (Pro20, Pro25, Pro Svan)
The machine has been designed for electrical ad- justment of a sand spreader (accessory).
12V | The switch is used to start and stop the |
| spreader. |
Cables for connecting the sand spreader are at the rear of the machine.
2.4.16 Clutch release lever (6:R)
A lever for disengaging the variable transmission. Enables the machine to be moved by hand without the help of the engine.
The disengagement lever must never be between the outer and inner positions. This overheats and damages the trans- mission.
Two positions:
1.Lever out – transmission en- gaged for normal operation. There is an audible click when the lever locks in the outer posi- tion.
2.Lever in – transmission disen- gaged. The machine can be moved by hand.
The machine may not be towed over long distances or at high speeds. The transmission could be dam- aged.
2.4.17 Seat (1:T)
The seat can be folded and adjusted front- rear. The seat can be adjusted as follows:
1.Move the control lever (1:T) upwards.
2.Set the seat to the desired position.
66
