ENGLISH
4.4Start
1.Open the fuel cock. See 14.
2.Check that the spark plug cable(s) is/are in- stalled on the spark plug(s).
3.Check to make sure that the power
4.Do not keep your foot on the drive pedal (3:F).
5.Put the throttle control at full throttle.
Starting cold engine – pull the choke control out fully.
Starting warm engine – the choke control should be pressed in.
6.Depress the
7.Turn the ignition key and start the engine.
8Once the engine has started, push the choke control in gradually if it has been used.
9.When starting from cold, do not make the ma- chine work under load immediately, but let the engine run for a few minutes first. This will al- low the oil to warm up.
When the machine is in operation, full throttle should always be used.
4.5Power assisted steering (Pro20, Pro25, Pro Svan)
Power assisted steering means that power from the machine’s hydraulic system is supplied to the steering wheel movements. This makes the ma- chine very easy to steer when the engine is operat- ing at working revs (full throttle).
The servo effect is reduced as the engine speed drops.
4.6Operating tips
Always check that there is the correct volume of oil in the engine. This is particularly important when operating on slopes. See 4.2.
Be careful when driving on slopes. No sudden starting or stopping when driv- ing up or down a slope. Never drive across a slope. Move from the top down or from the bottom to the top.
The machine may not be driven on slopes greater than 10º in any direction.
Reduce the speed on slopes and when making sharp turns in order to retain control and reduce the risk of tipping over.
Do not turn the steering wheel to full lock when driving in top gear and at full throttle. The machine can easily topple over.
Keep hands and fingers well away from articulated steering joint and seat bracket. Risk of crushing injuries. Nev- er drive with the engine casing open.
4.7Stop
Disengage the power
Allow the engine to idle
Shut off the petrol cock. This is particularly impor- tant if the machine is to be transported on a trailer for example.
If the machine is left unattended, re- move the spark plug cable(s) and re- move the ignition key.
The engine may be very warm immedi- ately after it is shut off. Do not touch the silencer, cylinder or cooling fins. This can cause burn injuries.
4.8Cleaning
To reduce the risk of fire, keep the en- gine, silencer, battery and fuel tank free from grass, leaves and oil.
To reduce the risk of fire, regularly check the machine for oil and/or fuel leakage.
Clean the machine after each use. The following instructions apply for cleaning:
•When washing the machine with water under high pressure, do not point the jet directly at axle seals, electrical components or hydraulic valves.
•Do not spray water directly at the engine.
•Clean the engine with a brush and/or com- pressed air.
•Clean the engine’s cooling air intake
•Only Pro25: Clean the oil cooler (12:X).
69
