ENGLISH

5.3 During use

Connect the machine using an extension lead to a 230 VAC electric socket. See “4.1.1 Electric sock- et and relieving loop”. The electric socket must have a 10 A fuse.

Set the desired cutting depth and start the machine. Start working on the lawn as close to the mains electric socket as possible in order to minimise the risk of running over the cable. The cable must not be run over under any circumstances.

Never stretch the cable; it should remain in a loose loop at the side of the machine.

5.4 After use

The machine must not be rinsed with water. This will damage the machine’s electrical components and can produce fatal electric shocks.

Stop the machine and disconnect the connection cable.

Clean the machine with a soft brush and a moist cloth.

Store the machine in a cool, dry location.

7 RECYCLING

Waste management in accordance with the WEEE Directive (2002/96/EC)

Take care of the environment!

Do not discard with household waste!

This product contains electrical and electronic components that must be recycled.

Hand the product in for recycling at the indicated location, e.g. the municipal recycling station.

6 MAINTENANCE

The machine must always be disconnect- ed from power when carrying out mainte- nance or repairs. Risk of crushing injuries and fatal electric shocks.

6.1 Regular maintenance

The machine requires no regular maintenance oth- er than cleaning, as described above.

6.2 Adjusting drive belt

1.Remove the belt cover and the motor casing by unscrewing the 5 screws in fig. 5.

2.Remove the inner motor casing.

3.Undo the motor’s adjustment screws. See fig. 6.

4.Push the motor forwards until the belt is cor- rectly tensioned. Check that the engine is ten- sioned equally on both sides.

5.Tighten the motor’s adjustment screws.

6.Reassemble the casings and covers. See fig. 5.

29

Page 9
Image 9
Stiga VE32 manual Recycling, Maintenance