8
A. Close the spigot and fill the hopper with 2 gallons
(8 liters) of tap water.
B. Place the switch in the CLEAN position. The auger
will start to rotate.
C. Allow the water to agitate for approximately 30
seconds.
D. Open the spigot to drain the water. Remember to
place a container under the spigot to catch the
water. When the water has drained, place the
switch in the OFF (middle) position. Allow the
freezing cylinder to drain completely.
E. Prepare detergent water by mixing 2 oz. of Palmolive
detergent or equivalent in 2 gallons of 90° to 110°F
(32° to 43°C) water. Repeat steps A through D
using the detergent solution.
3.8 DISASSEMBLY OF FREEZER PARTS
Inspection for worn or broken parts should be made each
time the freezer is disassembled. All worn or broken parts
should be replaced to ensure safety to both the operator and
the customer and to maintain good freezer performance and
a quality product. Frequency of cleaning must comply with
the local health regulations.
To disassemble the freezer, refer to the following steps:
A. Remove hopper cover. Pull the mix inlet regulator
straight up to remove it from the hopper.
B. Pull out the spigot pin by its ring.
C. Remove the spigot handle.
D. Remove front door by turning the circular knobs
and then pulling door off the studs.
NOTE
When removing front door, entire door and stator
assembly will come out as well.
E. Remove torque rod from stator assembly (Refer to
Figure 3-4).
F. Remove quad ring from groove in front door.
G. Remove stator bar. Remove o-ring and white bushing
from stator bar.
H. Remove auger support bushing.
I. Turn spigot body until the ice breaker bar can be
removed. Remove breaker bar (Refer to Figure 3-5).
J. Remove spigot body from the front door.
K. Remove o-rings (2) from the spigot by first wiping
off the lubricant using a clean paper towel. Then
squeeze the o-ring upward with a dry cloth. When
a loop is formed, roll the o-ring out of the groove
(Refer to Figure 3-6).
CAUTION
Hazardous Moving Parts
Revolving auger shaft can grab and cause injury.
Place the switch in the OFF (middle) position before
disassembling for cleaning or servicing.
Figure 3-4 Torque Rod
Figure 3-5 Spigot and Ice Breaker Bar Removal
CAUTION
Do not use any type of sharp object to remove the
o-rings.