10
D. Install the two plastic auger blades onto auger.
Blades may be attached in any orientation.
E. Push auger into freezing cylinder and rotate slowly
until auger engages the drive shaft (Refer to Figure
3-9)
F. Insert spigot body into front door.
NOTE
When inserting spigot body, press o-rings in to pre-
vent damage.
G. Turn spigot body until the ice breaker bar can be
inserted. Insert breaker bar and rotate spigot body
90°.
H. Install auger support bushing onto front door so
beveled edge of bushing is against door (Refer to
Figure 3-10).
I. Install the white stator support bushing onto the
rear of the stator bar and insert stator into spigot.
J. Insert torque rod. The rod should be placed through
the hole in stator bar.
K. Install the front door onto the freezer.
NOTE
When installing door onto freezer, torque rod must
be placed in the center of metal torque actuator arm
L. Install the knobs on the freezer studs.
M. Look for the proper seal between the freezing
cylinder, quad ring, and front door
N. Insert spigot handle so hole lines up and insert
spigot pin.
O. Install the mix inlet regulator into the hopper if using
shake mix. If using slush mix, the mix inlet
Figure 3-9 Auger Assembly
CAUTION
Do not place the mix inlet regulator into the hopper
before installing the auger. Attempting to install the
auger with the mix inlet regulator in place will dam-
age the mix inlet regulator.
CAUTION
Overtightening or uneven tensioning of circular knobs
may cause damage to front door and cause leaking.
Hand tighten knobs evenly.
Figure 3-10 Door and Stator Assembly