A.Assemble all "O" Rings onto parts dry, without lubri- cation. Then apply a thin film of sanitary lubrication to exposed surfaces of the "O" Rings. Apply a thin film of sanitary lubricant to metal part of rear seal. Also apply a thin film of sanitary lubricant inside and outside of the front auger support bushing.

B.Assemble the rear seal onto the auger with the large end to the rear. Be sure the "O" Ring is in place before installing the rear seal.

C.Lubricate the auger drive (rear) with a small amount of white socket lubricant. A small container of socket lubricant is shipped with the freezer.

D.Screw the springs onto the studs in plastic flights.

Springs must be screwed into the flights com- pletely to provide proper compression (Fig. 25).

Figure 25. Exploded View of Auger (E111 Shown)

CAUTION

DO NOT PLACE THE MIX INLET REGULATOR INTO THE HOPPER BEFORE INSTALLING THE AUGER.

E.Install the two plastic flights onto rear of the auger and insert part way into freezer barrel.

F.Install the remaining plastic flights, push the auger into the freezer barrel and rotate slowly until the auger engages the drive shaft.

G.Install the bushing and auger support into the front of the auger with one leg of the support pointing straight up.

NOTE

Apply a small amount of Petro-Gel to the surface of the cam on the spigot handle prior to assembly of handle to the spigot body.

H.Install the spigot body with "O" Rings and spring into the front door from bottom (Fig. 26). Push straight up until the spigot is in place. Place the spigot handle on top of the spigot and insert clevis pin, then install the adapter and rosette.

Figure 26. Exploded View of Front Door

NOTE

The spigot handle can only be installed one way.

I.Install the front door on the freezer. Shoulder on the rear of the door must be inside of freezer barrel.

J.Install the circular knobs on the freezer studs.

CAUTION

FINGER TIGHTEN THE CIRCULAR KNOBS EVENLY. DO NOT OVERTIGHTEN KNOBS.

Look for the proper seal between the freezer barrel, "O" Ring, and front door.

K.Install the mix inlet regulator into the freezer with the air tube to the front of the freezer (Fig. 27).

L.Install hopper cover and drain tray.

Figure 27. Mix Inlet Regulator3.12ROUTINECLEANING

To remove spilled or dried mix from the freezer exterior, simply wash in the direction of the finish with warm soapy water and wipe dry. Do not use highly abrasive materials as they will mar the finish.

13