Figure 13. Auger with Rubber Rear Seal

3.16DISASSEMBLY AND ASSEMBLY OF AUGER

To aid in the disassembly and assembly of the auger, refer to Figure 13 in the following steps:

CAUTION

TURN FREEZER OFF AT MAIN DRIVE SWITCH BEFORE DISASSEMBLING FOR CLEANING AND SERVICING.

A. Diassembly of auger

1.Remove the front auger support by pulling it straight out of the freezer barrel.

2.Remove the plastic bearing from the front auger support.

3.Remove the auger by pulling slowly and rotating out of the freezer barrel. As the auger is with drawn, remove each plastic flight and spring from the auger. (Fig.14)

NOTE

Be careful not to scratch inside of the freezer barrel when removing flights or augers.

Figure 14. Auger Disassembly

4.Keep the rear of the auger tipped up once it is clear of the freezer barrel. This prevents the auger seal from falling off.

5.Wipe spline lubricant off hex end rear of auger with a paper towel.

6.Remove the rear seal assembly.

7.After proper cleaning, inspect plastic parts and rear seal parts for wear and damage. (See Fig. 15)

Auger Flight

Front Auger Bearing

Figure 15. Plastic Parts

B.Assembly of Auger

NOTE

Petro-Gel sanitary lubricant or equivalent must be used when lubrication of parts is specified.

1.Install O-ring onto auger shaft dry (without lubrica tion).

2.Lubricate the O-ring and the inside of the rear seal adapter with a thin film of sanitary lubricant.

3.Install the rear seal adapter and seal in order as shown in Figure 16.

Figure 16. Auger Assembly

4.Lubricate the hex drive end of auger with a small amount of white spline lubricant.

NOTE

A small container of socket lubricant is shipped with the freezer.

16