10 | Installation |
Installing the Receiving Frame
NOTE: Use a #2 Phillips screwdriver for this procedure.
The drive should be installed into the carrier before installing the receiving frame into the mounting bay of a computer or expansion chassis.
1.Turn OFF power to the computer.
2.Open the computer system according to the manufacturer’s instructions. If neces- sary, temporarily remove any expansion boards that may make installation difficult.
3.With the drive carrier locked in place inside the receiving frame, install the DX115 into the 5.25” drive opening in the computer or expansion chassis. Use the appro- priate guides to position the Data Express, and fasten it into place with the four
(4) M3 Phillips screws provided. Figure 7 illustrates the location of the mounting holes. Mounting holes are provided on each side and the bottom of the receiving frame to accommodate a variety of mounting configurations. Use the mounting holes which best suit the computer or expansion chassis configuration. Note that bottom mounting holes require
4.Adjust the front of the receiving frame so the carrier slides freely in and out on the receiving frame guides. The position of adjoining peripheral units may require ad- justment.
Mounting
Holes
(Bottom)
Mounting
Holes
(Left)
Mounting
Holes
(Right)
Figure 7: Receiving Frame Mounting Holes
StorCase Technology, Inc. | DX115 for Backup User's Guide - Rev. A01 |
