INSTALLATION INSTRUCTIONS
INSTALLATION
5. FUELBED ARRANGEMENTS
Remove the cast iron door using the tool provided. The main ceramic components are inside the firebox.
NOTE: THE CAST IRON DOOR IS HEAVY, TAKE EXTREME CARE WHEN HANDLING TO AVOID DAMAGING THE OUTER CASING.
The fuel bed consists of 5 logs and 2 ash panels. The logs have letters A,B,C,D and E moulded into them for identification.
5.7Take the rear log A and place it up against the rear of the fire sitting on the two flat ledges of the burner. The two legs of the log should sit between the rear burner ports. See diagram 9. Ensure an equal gap between each side of the log and the side of the firebox.
9
AR1610
5.8Place log B on the left hand side of the burner with the location bar on the underside of the log fully located in the long slot of the burner. Make sure the log is as far to the left as possible. See diagram 10.
10
AR1611
5.1Place log C on the right hand side of the burner with the location bar on the underside of the log fully located in the long slot in the burner. Make sure the log is as far right as possible. See diagram 11.
11
AR1612
5.2Place log D across from the rear log A to log B on the left- hand side. There are
12
AR1613
5.3There are two ash panels which lay across the front of the burner skin. Place the panel with the flat edge facing the left side of the firebox. There are location holes on this log which fit over the screw holes of the burner skin.
13
AR1614
17
