USER INSTRUCTIONS
1.important informAtion and
HEALTH AND SAFETY
ALL APPLIANCES DESCRIBED IN THESE INSTRUCTIONS ARE HEAVY. SEEK ASSISTANCE FOR UNLOADING OR TO LIFT FOR INSTALLATION.
•Remove all packaging and throw away using your local recycling facilities
To remove the protective packaging and fitting kit from the logs inside a new appliance, choose the instruction corresponding to your model from Section 4 below.
How to Use these Instructions
The contents of Sections 1, 2 and 3 apply to all the models in our Electric Range.
The content of Section 4, Remove and Replace Door, gives different instruction for each model type.
• Select the relevant information for your model
1.1Do not locate this appliance immediately below a fixed socket outlet.
1.2All the
1.3Do not use this appliance in the immediate surroundings of a bath, shower or swimming pool or any other area where the appliance could come into contact with water or humidity, e.g. bathroom.
1.4WARNING: Do not allow the appliance to be covered or let the air inlet/outlet to become obstructed as the appliance may overheat.
1.5This appliance is not suitable for use outside the house. For indoor use only.
1.6Keep the power cord away from hot surfaces and hot conditions. Do not route the power lead in front of the appliance.
1.7This appliance must stand on a clean, level, firm surface. Do not stand the fire on a carpet. Ensure that furniture, curtains etc. are positioned no closer than 1 metre and the fire stands on a surface that can withstand temperatures of 90°C for prolonged periods. Do not allow rugs to be placed within 500mm of the front of the stove.
1.8When the fire has been installed, the position of the plug must be accessible.
1.9Where the electricity supply cable has to pass through a fire place, stone surround etc. ensure suitable rubber bushes are fitted at possible wear points.
1.10If installed in an open fireplace, blank off the chimney to reduce the risk of a back draught which can cause the safety
1.11If the electricity supply cable is damaged do not use the appliance until it has been replaced. For safety reasons the replacement has to be carried out by Gazco, a Gazco service agent or a similarly competent electrician.
1.12Do not use this appliance with any kind of timer, programmer or thermal control or other device that will switch the appliance on or off automatically.
1.13The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
1.14Do not operate the appliance if the appliance is damaged.
1.15 Repairs of electrical appliances must only be performed by an electrical engineer. Should the appliance fail to operate or in case of any damage, please contact our service centre for repair.
2.operating instructions
2.1GENERAL
Your fire is remote controlled and can be operated by the hand held infra red handset or by the controls on the right- hand side of the appliance.
2.2PREPARATION BEFORE USE
Batteries:
•Ensure that the handset battery is new and is inserted correctly
•Dispose of any worn out batteries safely at your recycling centre on replacement
When using the handset:
•Make sure you point it at the front of the appliance.
2.3LOCATION OF POWER SWITCH
The mains power switch is located on the control panel on the lower
•Switch ON before operating either the Remote control or
Manual controls
A beep is heard to indicate the fire is ready for use.
3
