Stovax Electric Stove Range Installation Instructions, Fitting Stoves, Fault Finding, Disposal

INSTALLATION INSTRUCTIONS

1. FITTING STOVES

Most stoves are heavy and do not require 'anchoring' to the hearth or floor but in certain circumstances the appliance can become unstable e.g. when leaning on the stove or similar. If this is likely, secure the appliance to the hearth or floor with suitably strong fixings.

1.1FOR MARLBOROUGH, MANHATTAN, STOCKTON, STOCKTON 5:

•Position the stove ensuring all appropriate clearances are observed

Using a pencil:

•Mark the position of the holes in the fixing brackets attached to the inside of the rear legs

•Remove the stove and drill holes using an appropriate

drill

•Push rawl plugs into the holes and insert the wood screws until the head is approximately 3mm proud of the hearth

•Place the stove in position over the brackets so that the screw heads locate in the large part of the slot

•Push the stove back so that the screw heads engage fully into the narrow part of the slot

•Tighten the screws if desired

1.2FOR THE F40 AVANTI

For Midi and Highline versions of the F40, you must remove the base panel of the carcass, Diagram 1

1

AR1471

Bolting down the fire

It is now possible to access the two tabs for bolting the fire down (if required):

•Position the stove, making sure all appropriate clearances are observed

Using a pencil:

•Mark the position of the holes in the fixing bracket.

Diagram 2

2

AR1456

•Remove the stove and drill the holes using a masonry

drill

•Insert rawl plugs

•Reposition the stove and level it using the three levelling bolts in the base

•Screw the fire down

•Replace the decorative base cover panel, if fitted

•Reassemble in reverse order

2.FAULT FINDING

2.1No illumination of the loose fuels, (or uneven lighting)

-first check if the heater is working. If YES, you probably need new bulbs. New bulbs are available from Gazco dealers and most electrical shops.

If NO, first change the 13amp fuse for one which you know works. If the fire still does not work, check the socket by plugging in an appliance you know is working. If this too fails to operate, call in a competent electrician to check the socket.

2.2Illumination but no heat - the safety cut-out has operated to protect against overheating. See note in Operating Instructions above but, in particular; ensure the air inlet and outlet grilles are free of dust or any other obstruction.

2.3Remote control fails to work - First check that the batteries are new and correctly fitted. Ensure that the handset is pointing at the window of the fire.

Disposal

This product must not be disposed together with domestic waste. This product has to be disposed at an authorised place for recycling of electrical and electronic appliances.

By collecting and recycling waste, you help save natural resources and make sure the product is disposed in an environmental friendly and healthy way.

13