SERVICING INSTRUCTIONS
REPLACING PARTS
1.GENERAL
1.1All principal components can be replaced without removing the stove from its installation, although it is essential that the gas supply to the appliance is turned off at the isolation device before proceeding further.
2.MAIN BURNER
2.1Turn the gas supply off at the isolation device, remove the door and place to one side, carefully remove the ceramic fuel bed components.
2.2Remove the three securing screws, two at the rear and one at the front
1
AR1605
2.3To replace the burner, engage the venturi over the injector ensuring the burner sits on top of the fixing bracket. Push the burner to the right and whilst holding, insert the three fixing screws.
NOTE: BEFORE REPLACING THE BURNER, ENSURE THE SILICONE SEAL AROUND THE INJECTOR IS INTACT AND CHECK THAT VENTURI COVER IS ATTACHED.
3.PILOT UNIT
3.1The pilot assembly consists of four components that can be individually changed, these are:
1)Pilot burner bracket
2)Pilot injector
3)Electrode
4)Thermocouple
3.2Turn the gas supply off at the isolation device. Remove the door and place to one side and carefully remove the ceramic fuelbed components.
3.3Remove the main burner. See Section 2 above.
3.4Remove the two fixing screws from the pilot bracket. See Diagram 2. Gently draw the assembly away from the firebox to give access to the nuts and ignition lead.
2
AR0614
3.5To remove the pilot injector, undo the compression nut on the pilot feed pipe and withdraw the injector which will be hooked onto the olive. When replacing an injector always make sure it is hooked onto the olive before inserting it into the pilot burner. See diagram 3.
3
AR1604
3.6To remove the electrode, disconnect the ignition lead and undo the retaining nut. The electrode can now be removed. Note the orientation of the electrode terminal when reassembling. See diagram 4.
4
AR0616
17
