Stow CS813H20, CC813H20, CS820H20 manual Stow Cutter 3 SAW 20HP Honda Engine Components

STOW CUTTER 3 SAW — 20HP HONDA ENGINE COMPONENTS

Figure 5. Engine Controls and

Components (Honda GX620TXF2)

INITIAL SERVICING

The engine (Figure 5) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturer's engine manual for instructions & details of operation and servicing.

1. Engine ON/OFF Switch – ON position permits engine starting, OFF position stops engine operations.

2. Fuel Tank - Holds unleaded gasoline. For additional information refer to engine owner's manual.

3. Throttle Lever – Controlled by accelerator pedal, increases or decreases engine RPM.

4.Choke Knob – Used in the starting of a cold engine or in cold weather conditions. The choke enriches the fuel mixture.

5.	Oil Sensor Switch – This switch monitors the oil level in
	the engine crankcase. In the event of low oil, the engine will
	be shut down.
6.	Oil Filter – Spin-on type, filters oil for contaminants.

7.Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.71 - 0.78 mm (0.028 - 0.031 inch) Clean spark plug once a week.

8.Fuel Filter – Filters fuel for contaminants.

9. Oil Filler Cap – Remove cap to refill or replace oil with recommended type as listed in Table 3. Make sure cap is tightened securely. DO NOT over fill.

10. Air Filter – Prevents dirt and other debris from entering the fuel system. Unsnap air filter cover to gain access to filter element.

11.Muffler –Used to reduce noise and emissions. NEVER touch the muffler while it is hot! Serious burns can result. NEVER operate the engine with the muffler removed.

WARNING

Engine components can generate extreme heat.To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

12. Oil Dip Stick – Remove to check amount and condition of oil in crankcase.

13.Starter – Starts engine when ignition key is rotated to the ON position.

14.Oil Drain Plug – Remove to drain crankcase oil.

PAGE 16 — STOW CUTTER 3 SAW — OPERATION & PARTS MANUAL — REV. #8 (09/22/06)