Stow CS813H20, CC813H20, CS820H20 manual Throttle Lever

STOW CUTTER 3 SAW — MANUAL START-UP (13HP HONDA ENGINE)

7. Place the throttle lever(Figure 23) halfway between FAST 9.	If the engine has started, slowly return the choke lever
and SLOW for starting. All sawing is done at full throttle. The	(Figure 22) to the CLOSED position. If the engine has not
engine governor speed is factory set to ensure optimum	started repeat steps 1 through 8.
blade operating speeds.
10.	Before the saw is placed into operation, run the engine for
	several minutes. Check for fuel leaks, and noises that would
	associate with a loose guard and/or covers.
11.	All sawing is done at full throttle. Your engine governor has
	been set at the factory to ensure an optimum speed setting.

Figure 23.Throttle Lever

8.Grasp the starter grip (Figure 24) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

CAUTION

zDO NOT pull the starter rope all the way to the end.

zDO NOT release the starter rope after pulling. Allow it to rewind as soon as possible.

Figure 24. Starter Grip

STOW CUTTER 3 SAW — OPERATION & PARTS MANUAL — REV. #8 (09/22/06) — PAGE 25