Stow CC813H20, CS813H20 Stow Cutter 3 SAW Inspection Blade Placement, Diamond Blade Placement

STOW CUTTER 3 SAW — INSPECTION - BLADE PLACEMENT

NOTE	The following steps should be
	accomplished before placing the
	diamond blade on the blade shaft.

■Set the engine ON/OFF switch to the OFF position.

■Raise the saw to a high position by cranking the Raise/Lower handle in a counterclockwise direction.

■Use the Blade Nut Wrench & Blade Shaft Locking Wrench stored on the front section of the console to install the diamond blade.

■Reference Figure 12 (Diamond Blade Placement) when removing or installing the diamond blade.

1. Blade Guard – Raise the front half of the blade guard to expose the blade shaft nut & outer flange.

2. Blade NutWrench – Remove the blade nut wrench (3) from the tool holder and unscrew the blade shaft nut (right-side). This nut loosens clockwise and tightens counter- clockwise.

3.	Blade Nut – Remove the blade nut (4). For reassembly,
	DO NOT over tighten the blade nut against the outer flange.
	Tighten blade nut approximately 45-50 ft-lbs/62-69 N/m.
4.	Outside Blade Flange (Collar) – Ensure that the flange
	face is clean and free of debris and is placed flush against
	the diamond blade (7). Check that the drive pin goes through
	the blade pin hole (6) and seats properly into the inner
	flange (8).
5.	Blade Pin Hole – Align this hole with the drive pin hole on
	the inner flange collar.
6.	Diamond Blade – Ensure that the proper blade has been
	selected for the job. Pay close attention to the directional
	arrow on the blade, clockwise for right-sidecutting,
	counter-clockwise for left-side cutting. The arbor hole
	of the blade must match the 1" arbor of the blade shaft.
7.	Inner Flange Collar – This flange is fixed upon the blade
	shaft, and is manufactured with a drive pin hole.The inside
	surface of the flange must be free of debris and permit a
	tight closure on the surface of the blade.

Figure 12. Diamond Blade Placement

STOW CUTTER 3 SAW — OPERATION & PARTS MANUAL — REV. #8 (09/22/06) — PAGE 21