STOW CUTTER 1 CE SAW — INITIAL START-UP
INITIAL START-UP
CAUTION
DO NOT attempt to operate the saw until this manual has been read and thoroughly understood. Engine operating steps may vary. See included engine manufacturer's operating manual.
CAUTION
Ensure the work area is clear of tool, debris, and unauthorized people.
The Engine Stop Switch located on the handlebar (Figure 14) serves both as
NOTE an Emergency Engine
CAUTION
NEVER place hands or feet inside the belt guard or blade guard while the engine is running. ALWAYS shut the engine down before performing any kind of maintenance service on the saw
1.Keep Wheel Clamp (Figure 15) applied (lever DOWN) until completely ready for cutting o peration.
Figure 15. Wheel Clamp
2.Ensure the diamond blade has been mounted correctly and that it is raised above the surface you are about to saw.
3.Place the fuel valve lever (Figure 16) to the "ON" position.
ENGINE STOP SWITCH
(Emergency Stop
and Primary ON/OFF)
ENGINE STOP
SWITCH
(Secondary ON/OFF)
CUTTER1
Figure 14. Engine Stop Switches
Figure 16. Engine Fuel Valve Lever
4.Place the ENGINEON/OFFswitchlocated on the ENGINE (Figure18)inthe"ON"position. PlacetheENGINEON/OFF switch located on the HANDLEBARS (Figure 14) in the "ON" (center) position.
WARNING
NEVER operate the saw in a confined area or enclosed structure that does not provide ample free flow of air.
ALWAYS wear approved eye and hearing |
|
protection while operating the saw. | Figure 17. Engine ON/OFF Switch (On Engine) |
|
STOW CUTTER 1 CE — OPERATION MANUAL — REV. #2 (12/20/07) — PAGE 21
