STOW CUTTER 1 CE SAW — OPTIONAL WATERTANK
WATERTANK KIT (OPTION)
An optional water tank kit is available for use with the CUTTER 1 CE Saw. The following steps are instructions for the assembly of the kit onto your CUTTER 1 CE Saw.
5.After determining the correct spacer length, place the spac- ers (item 12, Figure 24) between the engine block and the tank shelf bracket and secure the assembly with the 3/8" hardware(items6,8,and10). Usetheappropriatelengthbolt (item 6) for your application.
CAUTION
Make certain all bolts securing the kit to the saw are tight before operating the saw.
CAUTION
DO NOT use a water tank larger than 5 gallons (18.95 liters) with this kit.
While the optional water tank kit is excellent for
NOTEoperations, the use of a pressurized, continual water source may be preferred for longer or sustained cutting.
1.Locate all parts listed in the parts list.
2.Slide the Tank Shelf (item 1, Figure 24) over the top of the engine so the recoil starter fits through the large opening in the shelf. The recoil starter handle must be accessible throughthisopening.Ensuretherecoilstarterhandlecanbe pulled without binding or interference with the shelving.
3.Mount theTank Shelf to the frame using hardware items 7, 9, 11, and 13 to attach the shelf to the frame utilizing existing slots in the frame.
4.Locate the spacers for the tank mount. This kit provides spacers for two different engine options. The spacers are identified as:
Honda 9HP - use
18
| 10 |
7 | 6 |
| |
11 | 12 |
| |
9 |
|
13
Figure 24. Water Tank Kit (Option)
6.ConnecttheSwivelConnector(item5,Figure25)tooneend of the hose (item 3) with clamp (item 2).
7.Remove the hard plastic tube from the valve on the Water Tank (item 14). Slide this tube into the open end of the hose (item 3) to a depth of approximately 1inch (25.4mm). Fasten with clamp (item 2).
3 
14
22
5
Figure 25. Hose and Clamps
8. Replacethehardplastictubebackintothe WaterTankvalve.
STOW CUTTER 1 CE — OPERATION MANUAL — REV. #2 (12/20/07) — PAGE 27
