Stow STOW CP-20H- BASIC ENGINE, Danger, Engine Controls and Components, Initial Servicing

Models: CP-20H

1 68
Download 68 pages 19.17 Kb
Page 14
Image 14
STOW CP-20H — BASIC ENGINE

STOW CP-20H — BASIC ENGINE

Figure 3. Engine Controls and Components

INITIAL SERVICING

The engine (Figure 3) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers engine manual for instructions & details of operation and servicing. The engine shown above is a HONDA engine, operation for other types of engines may vary somewhat.

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

DANGER

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the

engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

3. Engine ON/OFF Switch – ON position permits engine

 

starting, OFF position stops engine operations.

4.

Recoil Starter (pull rope) – Manual-starting method. Pull

 

the starter grip until resistance is felt, then pull briskly and

 

smoothly.

5.

Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop

 

the flow of fuel.

6.

Choke Lever – Used in the starting of a cold engine, or in

 

cold weather conditions. The choke enriches the fuel

 

mixture.

 

7.

Air Cleaner – Prevents dirt and other debris from entering

 

the fuel system. Remove wing-nut on top of air filter

 

cannister to gain access to filter element.

 

 

Operating the engine without an

 

NOTE

air filter, with a damaged air filter,

 

or a filter in need of replacement

 

 

 

 

will allow dirt to enter the engine,

 

 

causing rapid engine wear.

8.

Spark Plug – Provides spark to the ignition system. Set

 

spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean

 

spark plug once a week.

 

9.

Muffler – Used to reduce noise and emissions.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER

operate the engine with the muffler removed.

10. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.

PAGE 14 — STOW CP-20H CENTRIFUGAL PUMP — PARTS MANUAL — REV. #0 (05/30/03)

Page 14
Image 14
Stow manual STOW CP-20H- BASIC ENGINE, Danger, Engine Controls and Components, Initial Servicing