Stow manual Stow MS-70 PLASTER/MORTAR Mixer Inspection, Before Starting, Engine Oil Check

STOW MS-70 PLASTER/MORTAR MIXER — INSPECTION

Before Starting

1.Read all safety instructions at the beginning of manual.

2.Clean the mixer, removing dirt and dust, particularly the engine cooling air inlet, carburetor and air cleaner.

3.Check the air filter for dirt and dust. If air filter is dirty, replace air filter with a new one as required.

4.Check carburetor for external dirt and dust. Clean with dry compressed air.

5.Check fastening nuts and bolts for tightness.

CAUTION	Eyesight and Hearing
	Protection

ALWAYS wear approved eye and hearing protection before operating the mixer.

3.Insertandremovethedipstickwithoutscrewingitintothefiller neck. Check the oil level shown on the dipstick.

4.If the oil level is low (Figure 10), fill to the edge of the oil filler hole with the recommended oil type (Table 7).Maximum oil capacity is 2.33 qts. (1.09 liters)

NOTE	Reference manufacturer engine
	manual for specific servicing
	instructions.

CAUTION	Inspection &
	Maintenance Saftey

NEVER place hands or feet inside the engine guard cover while the engine is running. ALWAYS shut the engine down before performing any kind of maintenance service on the mixer.

Engine Oil Check

1.To check the engine oil level, place the mixer on secure level ground with the engine stopped.

2.Remove the filler dipstick from the engine oil filler hole (Figure 9) and wipe it clean.

Figure 10. Engine Oil Dipstick (Oil Level)

Table 7. Oil Type

Season	Temperature	Oil Type
Summer	25°C or Higher	SAE 10W-30
Spring/Fall	25°C~10°C	SAE 10W-30/20
Winter	0°C or Lower	SAE 10W-10

Figure 9. Engine Oil Dipstick (Removal)

STOW MS-70 MIXER — OPERATION MANUAL — REV. #3 (03/26/10) — PAGE 21