MS-70 PLASTER/MORTAR MIXER — START-UP PROCEDURES
4.Turn the engine switch (Figure 14) to the ON position.
Figure 14. Engine ON/OFF Switch
5.The main start/stop switch located on the engine cover is (Figure 15) is used to start and stop the engine. Pull this switch outward to start the engine.
Figure 15. Start/Stop Switch (gasoline engine)
CAUTION Preventing Drum Tipping
Make certain the drum lock pin (Figures 17 and 18) is placed to the RIGHT (when viewing the mixer from the towpole end) of the drum stop block which is welded to the front side of the drum. Also make sure lock pin is fully engaged (locked).This will prevent the drum from tipping.
Figure 17. Drum Lock Pin (Side-View)
6.Place the belt slip lever (Figure 16) in the START/STOP (disengaged) position.
Figure 18. Drum Lock Pin (Right Position)
7.Pull the starter grip (Figure 19) lightly until you feel resistance, then pull briskly. Return the starter grip gently.
Figure 16. Belt Slip Lever |
|
(Start/Stop Position) | Figure 19. Starter Grip |
PAGE 24 — STOW
