PORTO-SCREED PSH— BASIC ENGINE

Figure 6. Engine Controls and Components

INITIAL SERVICING

6.

Choke Lever – Used in the starting of a cold engine, or in

The engine (Figure 6) must be checked for proper lubrication and

 

cold weather conditions. The choke enriches the fuel

filled with fuel prior to operation. Refer to the manufacturer's engine

 

mixture.

manual for instructions & details of operation and servicing. The 7.

Air Cleaner – Prevents dirt and other debris from entering

engine shown above is a HONDA engine, operation for other

 

the fuel system. Remove wing-nut on top of air filter

types of engines may vary somewhat.

 

cannister to gain access to filter element.

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

DANGER

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

3. Engine ON/OFF Switch – ON position permits engine starting, OFF position stops engine operation.

4. Recoil Starter (pull rope) – Manual-starting method. Pull the starter grip until resistance is felt, then pull briskly and smoothly.

5.Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop the flow of fuel.

 

 

 

 

Operating the engine without an air

 

NOTE

 

filter, with a damaged air filter, or a

 

 

filter in need of replacement will

 

 

 

 

allow dirt to enter the engine, causing

 

 

 

 

rapid engine wear.

8.

Spark Plug – Provides spark to the ignition system. Clean

 

spark plug once a week.

9.

Muffler – Used to reduce noise and emissions.

 

 

 

 

 

 

WARNING

 

 

 

 

 

 

 

 

 

Enginecomponentscangenerateextremeheat.

 

 

 

To prevent burns, DO NOT touch these areas

 

 

 

while the engine is running or immediately after

 

 

 

operating. NEVER operate the engine with the

 

 

 

muffler removed.

 

 

 

 

 

10. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.

11.Oil Drain Plug – Remove this plug to remove oil from the engine's crankcase.

12.Dipstick/Oil Filler Cap – Remove this cap to determine if the engine oil is low. Add oil through this filler port as recommended in Table 3.

PAGE 14 — STOW PORTO-SCREED — OPERATION & PARTS MANUAL — REV. #1 (03/17/04)

Page 14
Image 14
Stow PSH Initial Servicing, Mixture, Spark plug once a week, Muffler Used to reduce noise and emissions, Muffler removed