Studer Innotec C3548 COMPACT Remote Control, Maximum Contact load -230Vac /16Amp-30Vdc/1A

STUDER INNOTEC COMPACT

Maximum Contact load: -230Vac /16Amp-30Vdc/1A!

With the Push Button 21 „AUXILARY CONTACT“ the contact can be manually switched on or off independent of programming and the operating situation. The LED 5 “Contact active” show the state of the contact. The drawing up the screw terminal “AUX CONTACT” is the inactive position mode, LED 5 “Contact active” off.

The switching on and off of this contact can be freely programmed for every operating situation of the COMPACT witch situation is indicated with a LED. There is no limitation to its application and it is left to your wishes and desires as to where and how you would like to use it. The example and the setting of this contact are explain chapter 5.4.2.

In factory we program this for a dysfunction alarm. The contact is active when one of these situations are detected:

•Over temperature (LED 10 lit)

•Overload (LED 11 lit)

•Over or less voltage of batteries (LED 12 lit or blink)

•COMPACT is turned off manually or with a fault (LED 13 lit)

4.10The Remote Control

As an option a Remote Control can be connected to the COMPACT. All operating controls and displays except from level adjustment are available on the Remote Control. The Remote Control is supplied with a 20m long cable. It can lengthened to 40m. The Remote Control is suitable for surface mounting on the wall or on to a switch board. It is fixed with 4 screws. The COMPACT can also be programmed with the Remote Control. The Programming is described in the section „Programming“.

The output power and the charging currents are displayed on the Remote Control.

COMPACT	INVERTER - CHARGER
RCC-01	TRANSFER
AC IN	AC OUT	A	%
			160
CHARGER	INVERTER		130
	RESET	70	100
SOLAR CHARGE		60	80
	ALARM
	(Select)	50	60
EQUALIZE	Over Temp.	40	40
		30	20
Program	Overload	20	10
	Battery	10	5
Contact active	Low/High	Charger
			Inverter
Contact manual	OFF
AUXILIARY CONTACT	ON/OFF
(Program)	(Change status)

In the Remote Control there is an additional Alarm Contact and a Control Input built in. These two functions are available through Tip-jack RJ11/4 for use. This Auxiliary Contact is Front / Work Contact (max. 0.5A!), which is independent of the Auxiliary Contact of the COMPACT. This contact is active in case of an alarm of the COMPACT.

						contorl
						Remote
! -batt !
ON/OFF
	1	2	3	4
COMPACT					60V/0,5A
Remote control
					max.
Dry contact
only

The Control Input is connected in parallel to the ON/OFF- push button. The COMPACT can be switched on or off through this input with an impulse button or an impulse contact.

Order Number for Remote Control: RCC-01

Dimensions: H x B x T / 111.5 x 136.5 x 25mm

Caution: No external voltage should be connected to this Input Control.

User manual COMPACT V2.0 E 18