Sub-Zero CT36E dimensions Installation N O T E S

Planning Information

36" (914) Framed Electric Cooktop

M O D E L C T 3 6 E

I N S T A L L A T I O N N O T E S

Refer to the illustrations and specifications for overall dimensions, cut-out dimensions and installation specifics.

Wolf recommends using 39" (991) cabinets with the 36" (914) cooktop.

A Wolf downdraft system, Cooktop or Pro ventilation hood is recommended. When installing a ventilation hood, refer to the specific requirements of the hood for the minimum dimension to the countertop. Also refer to Ventilation Recommendations in the Cooktop Ventilation or Pro Ventilation sections of our website, wolfappliance.com.

The Wolf 36" (914) framed electric cooktop requires a separate, grounded 3-wire 240 V AC, 60 Hz, 50 amp or 208 V AC, 60 Hz, 40 amp service with its own circuit breaker. It is provided with a 4' (1.2 m) flexible 3-wire conduit for connection at the electrical supply. Locate electrical within the shaded area shown in the Installation Specifications illustration on page 4.

IMPORTANT NOTE: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation.

A Wolf 36" (914) or 30" (762) built-in single oven may be installed below this cooktop. For this installation, the electrical supply for the cooktop should be installed in the adjacent cabinet. Refer to page 6 for additional specifica- tions. Be aware of the depth of the cooktop when planning for this installation.

IMPORTANT NOTE: Wolf electric cooktops are designed and agency approved for installation with Wolf built-in ovens only.

IMPORTANT NOTE: When a built-in oven is installed below the cooktop, unless you are using cabinets deeper than 24" (610), it is recommended that the electrical supply for the oven be placed in an adjacent cabinet within reach of the conduit. A 2" (51) diameter hole to route the conduit through cabinetry will be required. Refer to page 6 for location of electri- cal supply and additional specifications.

You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service.

When a 36" (914) oven is installed below a cooktop, it is recommended that the rough opening for the oven be 7 3/4" (197) from the floor to ease the use of the oven door. The bottom cabinet support must be able to support 250 lbs (113 kg).

If the 36" (914) framed electric cooktop is to be used with any combination of additional cooktop units or modules with a filler strip, the cut-out width increases to 35" (889). When multiple cooktop units or modules are installed side by side, refer to the countertop cut-out dimensions on page 7.

Refer to the installation instructions shipped with each Wolf product for detailed specifications.

This cooktop is intended for indoor use only.

Dimensions in parentheses are in

millimeters unless otherwise specified. 5