Summit ENG. 4358-3412E instruction manual Troubleshooting, Installation Tips

4358-3412E Summit 3/2/07 2:55 PM Page 45

6

From the back, use a screwdriver to press in on lip of upper harness guides and pop guides through the front. Pull cover off headrest.

Hand wash with warm sudsy water, rinse clean and air dry. Do not use bleach or use other harsh cleaners. Do not dry clean.

Spot clean harness straps. Do not machine wash.

Troubleshooting

✔1. If your child restraint is not held securely by the belt:

Press down firmly on the child restraint and remove all the slack in the belt. Make sure the belt buckle is not up against the child restraint where the belt cannot be tightened.

Review Locking Clip section and Top Anchorage Strap Section. If you cannot secure the child restraint tightly, move it to another seating location.

✔2. If the child restraint buckle or harness release lever sticks or you cannot get the straps tight enough around child:

DO NOT LUBRICATE. Check around buckle and harness release lever for dropped food, sticky spilled drinks, dirt, leaves, etc. Clean with warm water and/or remove object

Replace seat pad by reversing order:

Put pad on headrest and replace harness guides.

Make sure harness guides tabs go over metal bar.

Starting from bottom of child restraint, snap pad on shell; tuck in pad around harness adjuster; pull pad up and over headrest. Attach the elastic straps. Make sure pad is under headrest and replace lower harness guides. Rethread harness (see belt-positioning booster section).

with tweezers. If you cannot get the harness to adjust and remain tight with the buckle securely locked, do not use the child restraint.

✔3. If your harness twists or ropes:

Straighten the harness each time you put your child in the seat to help prevent twisting. Lock the buckle and tighten harness and it will be ready for next use.

Installation Tips:

When using the interal harness, the harness must be positioned at or above the child’s shoulders.

When using the internal harness, make sure the vehicle lap belt is locked. When you grasp the the child restraint at the belt path, it should not move more than about an inch side to side.

42 43