4358-3412E Summit 3/2/07 2:55 PM Page 27

Forward-Facing Installation

After deciding whether to use your Vehicle Belts or LATCH, be sure to read the warnings below as they pertain to both systems.

When LATCH is not being used, fasten belt hooks together behind the child restraint as shown.

!WARNING:

Loose LATCH hooks can result in serious injury or death.

Forward-Facing Installation with Vehicle Belts:

1

Connect and tighten

harness straps prior to

 

installing in vehicle.

Place child restraint flush

against the back of the

vehicle seat forward-

facing in the back seat.

The recline position is to be used only to install the

child restraint flush against the back of the vehicle seat back, if needed.

Thread the vehicle lap belt or lap/shoulder belt combination through the belt path and out other side. Buckle.

2

Place one knee in the

child restraint and push

 

down firmly while pulling

 

up on belt to tighten. For

 

a manual belt, refer to

 

“Knowing your Vehicle

 

Belt” section.

3

With knee still in child

restraint, attach hook to

 

anchor in vehicle. Push

 

down firmly and tighten

 

top anchorage strap.

To adjust top anchorage

strap: See “Adjusting Top Anchorage Strap” section.

NOTE: If your vehicle does not have an anchor bracket, tuck the top anchorage strap’s hook under the child restraint.

Forward-Facing Use: 22-40 lbs. (10.1-18 kg), 34-43” (85.1-110 cm), Over 1 year of age.

24

25

continued on next page.

Page 14
Image 14
Summit ENG. 4358-3412E instruction manual Forward-Facing Installation with Vehicle Belts