Summit P4045, P4014, P4015 manual Pcr

UNINETIMAGINGHP P4014,INCINC. . •P4015• BROTHER& P40451240/1650CARTRIDGE REMANUFACTURING• • DISASSEMBLINGINSTRUCTIONSTHETHETONERCARTRIDGE

44.Install the arm onto the cartridge. Pull the arm fully back to release the spring from the notch. Check to make sure the drum cover operates properly.

45.Remove the old chip from the top of the cartridge by slic- ing the melted plastic off with a sharp X-Acto knife. Replace the chip, then lock in place with a small dab of glue from a hot glue gun. Replacing this chip will enable the toner low func- tions of both the cartridge and the machine again.

REPETITIVE DEFECT CHART
OPC Drum:		94mm
Upper fuser sleeve		94mm
Lower fuser pressure roller		94mm
Tray 2 - Separation roller		79mm
Tray 2 - Pickup roller		79mm
Tray 2 - Feed Roller		79mm
Tray 1	- Separation Roller	79mm
Tray 1	- Feed Roller	79mm
Tray 1	- Pickup roller	63mm
Magnetic roller		63mm
Transfer Roller		47mm
PCR		37.7mm

SUMMIT

3232 West El Segundo Blvd., Los Angeles, California 90250 USA • Ph +1 310 280 9620 • Fx +1 310 838 7294 • techsupport@uninetimaging.com • www.uninetimaging.com

© 2008 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.