Sun Lawn MM-2 owner manual Assemble The Handle Sections, Adjusting The Cutting Height

Owner’s Manual — Sunlawn MM-2

ASSEMBLE THE HANDLE SECTIONS

1.Set the cutting height to the highest setting as shown below. This will make it easier to attach the lower handle section.

a.Loosen the two large black knobs [Part # 9], one on each side of the mower body, to allow movement of the height adjustment arms [Part # 11]. NOTE: the handle is mounted to the adjusting arms and thus moves with the arms.

b.Set the height to the highest setting and re-tighten the black knobs.

2.Fit the lower section of the handle [Part # 4] so that the holes are over the handle posts on the mower. [See Insert B] Then rock the handle to align the locking tabs and allow the handle section to fit into place. Place the spacer [Part # 7] over the post and put the cotter pin (Part # 8] through the hole to secure the handle.

3.Continue assembly of the middle [Part # 3] and top sections [Part

# 1] of the handle using the handle bolts and wing nuts [Part # 5 and 6].

ADJUSTING THE CUTTING HEIGHT

The cutting height of the MM-2 may be adjusted from approximately

1.0inch up to approximately 2.9 inches. Actual height may vary according to the height of the turf. Adjust the mower to the desired height as follows:

3