Owner’s Manual — Sunlawn
If the lawn is overgrown (to higher than 4 inches) it may be advisable to use a brush cutter to remove the excess turf mass before resuming mowing at normal heights.
MAINTENANCE
CLEANING
After using the mower, clean with a moist cloth. Spray the cylinder and cutting bar with silicon spray lube.
GENERAL MAINTENANCE
Regularly check to insure that all bolts, nuts, and screws are tight and that the mower is in good working order. Worn out and damaged parts should be replaced.
The blades, if properly cared for, will mow for years before requiring sharpening. Sharpening can only be done by a professional using a cylinder grinder and proper techniques.
STORAGE
1.Store the
2.The mower should be stored out of the reach of children.
READJUSTING THE BLADE CLEARANCE
The blades are optimally adjusted from the factory. However, after using the mower for a long period, if the cut is not clean, the blades need readjusting. The procedure is as follows:
1.Turn the mower over to expose the cutting bar on the bottom of the mower. [Part # 17].
Using a 10mm open end wrench, tighten the hex bolt approximately 1/4 turn [Part # 19] at one end of the cutting bar until the cutting bar and cylinder come into contact. Spin the blade cylinder by hand and back off the bolt approximately 1/8 turn or until the cutting bar and cylinder are no longer in contact.
7
