Sun Lawn MM-2 owner manual Technical Data

Owner’s Manual — Sunlawn MM--2

2.Make the same adjustment at the other end of the cutting bar.

3.Now check the adjustment using the small 0.05mm/0.002 inch gauge (silver strip) supplied with the MM-2 (or any 0.05mm/0.002 inch feeler gauge). If the gauge is held by the cylinder blades but the cylinder and cutting bar are not touching then the adjustment is correct.

4.The blades may also be tested by inserting a piece of paper vertically into the blades while turning them by hand.

!

WARNING

Blades are sharp! Be careful of injury — handle the blades carefully to avoid cutting yourself. Wear appropriate gloves or hand protection.

		TECHNICAL DATA
Mower	Cutting width:	40 cm (16 inches)

Cutting height rough (from floor): 1.0 to 2.9 inches

8