Sun Microsystems 802-1304-10 manual Net-Install Servers Solaris 2.3 Hardware 5/94 Only

which automatically installs the driver SUNWbmac. For the “Entire Distribution”, “Programmer” and ”End User Support” clusters, the driver is installed only if SunFastEthernet Adapter hardware is installed in the system.

Table 1 Solaris 2.3 Hardware: 8/94 CD

Cluster	Size
Entire Distribution plus OEM Support	298.80 MByte
Entire Distribution	298.1	MByte
Programmer	220Mbyte
End User System Support	125.37 MByte
Core System Support	59.88	MByte

If SunFastEthernet hardware was not installed when the Solaris 2.3 Hardware: 8/94 software distribution was installed using one of the last four clusters, then the driver is not automatically installed via suninstall, instead, the driver must be installed using the pkgadd command. Refer to “Adding SUNWbmac using Pkgadd Command”, page 5, in the SunFastEthernet User Guide, P/N 801-6109-10.

Net-Install Servers (Solaris 2.3 Hardware: 5/94 Only)

Note – The Solaris CD cannot be used to do a net-install (read only), thus the following section is applicable only when the Solaris CD image is archived to a disk.

To allow net-install over the be interface the be minor-device- number must be added to your particular architecture’s name_to_major file. To determine the be minor-device-number proceed as follows:

1.Determine the directory where the Solaris CD image is loaded.

For example, if the Solaris software is located within a directory named DIR, then type the following:

#cd DIR/export/exec/kvm

2 SunFastEthernet Adapter—July 1994