Sun Microsystems manual Model DVC-3Digital Video Coach, Operation Summary

Model DVC-3 Digital Video Coach

The same 2 patterns are also useful for Video-over-UTP Category cable both for the high-frequency loss compensation (above paragraph), but also for Skew Compensation for those devices that give you this flexibility. The right and left edges of the RGB bars should vertically line-up. Again, this pattern gives you a convenient means for making this adjustment.

Operation Summary

‰To change the resolution being produced press the OUTPUT MODE button repeatedly. The output screen has an OSD to indicate the resolution and refresh rate settings

NOTE: It is possible to set the output resolution to one that your monitor does not support. In this case you my not get a screen. You can either keep pressing the OUTPUT MODE button as it eventually goes through all the available outputs in a circular fashion, or use 2-button “Quick Select” combination to jump to a specific output immediately.

‰To change pattern press the + or – keys.

‰To get analog high res. component video output at the HD15 connector (instead of VGA), slide the switch to YPbPr and press the 480p “Quick Select”. The LED will turn on to indicate that there is a valid component output signal present. NOTE: If the LED is not on that means you are not getting a proper analog component output! Either the output MODE is not at one of the HDTV settings, or the slide switch is not in correct position.

NOTE: The DVI connector outputs all available resolutions (both PC and HDTV)

‰When you change the output, the DVC-3 memorizes your settings after 8 seconds and the next time the unit is tuned on it will recall the memorized settings.

8