Sun Microsystems SPARCserver 1000 manual For both packages, answer / to the following question

1

9.Power off your system, using standard shutdown procedures described in Solaris 2.5 Handbook for SMCC Peripherals.

10.Install the SunSwift SBus Adapter as described in Chapter 2.

1.3.2Using the SunSwift SBus Adapter and Existing Ethernet Interface

You will be installing software from the Solaris 2.5 CD-ROM. Make sure the Solaris 2.5 CD-ROM is properly placed in the CD-ROM drive before performing the following tasks.

If you want to use the SunSwift SBus Adapter Ethernet interface and your existing Ethernet interface, you must perform the following tasks before installing the SunSwift SBus Adapter.

Note – Make sure you have an Ethernet cable for each Ethernet interface.

1.As superuser, add the SUNWhmd and SUNWhmdu packages to your system:

#pkgadd -a none -d /cdrom/solaris_2_5_sparc/s0/Solaris_2.5 SUNWhmd SUNWhmdu

2.For both packages, answer / to the following question:

Enter path to package directory [?,q]

You will receive a message stating the process was successful.

3.Assign an IP address and host name for the SunSwift SBus Adapter Ethernet channel.

For example, 123.456.78.90 (IP address); zardoz (host name).

4.Edit the /etc/hosts file and add an entry containing the new IP address and host name for the selected hme channel.

This is the IP address and host name that you assigned in step 3.

Preparing for Installation 1-5