At the | end | of | the | testing interval, (up to 30 | seconds) | the | display | will | indicate | the | ||||||||
level of airborne allergens particles measured. | If the display indicates a | moder- | ||||||||||||||||
ate(yellow | light) or | high(red) | level, | the | air | cleaner will | automatically turn | on | for | |||||||||
30 | minutes. | At | the | end of 30 minutes, the | sensor will resample the air (blinking | |||||||||||||
green | light). | If | the | level | of | allergen particles | detected | by | the sensor | is | less |
| ||||||
than | the sensitivity | setting you selected, | the | air cleaner will remain off, and the | ||||||||||||||
sensor | will | continue | to | constantly | sample | the air | (blinking | green | light) | until | it | |||||||
detects | that | the | particle | level | has | exceeded | the | sensitivity | setting | you | chose. |
|
TO RUN YOUR AIR (LEANER MANUALLY...
1. Turn the sensitivity setting to the OFF/manual position.
2. Choose one of the four fan speeds (sleep, low, medium, high). The air cleaner will run continuously until you shut it off.
TO USE THE IONIZER...
Push down the ionizer button. The indicator light will come on. The ionizer is now operating and will continue to operate whether
the air cleaner is on or off.
1. | Place | your | air cleaner near the center of | the room | or | in | an | area | where | the | unit | |||||||||||||||
| can operate without impediments to the airflow. |
|
|
|
|
|
|
|
|
| ||||||||||||||||
2. | Turn | your | air | cleaner | so | that the | Allergysmart | detector | can | freely | sample air | (do | ||||||||||||||
| not |
| put | the detector | in | a | corner | or | otherwise | impede | air | flow | to | the detector). | ||||||||||||
3. | Experiment | with | the | location | and | sensitivity and | fan speed | settings | on | your | unit. | |||||||||||||||
| If | you | feel | that your home’s air continues to contain | allergen | particles | after |
| ||||||||||||||||||
| running the unit at a low fan speed (sleep, low or medium) | or | at | a | lower |
| ||||||||||||||||||||
| sensitivity | setting | (average | or | extra), | try | increasing | the | fan | speed | to | medium | ||||||||||||||
| or | high | and/or | increasing | the | sensitivity | setting | to | extra | or | super. |
| You | can |
| |||||||||||
| also try repositioning the unit in your room. Remember that the higher the | |||||||||||||||||||||||||
| sensitivity setting, with super being the | highest, | the | lower | the | particle | count | |||||||||||||||||||
| required to cause the unit to turn on. If you feel that the unit is running |
| ||||||||||||||||||||||||
| too |
| often, | reduce | the | sensitivity | setting | (i.e. | change | the sensitivity | setting |
| ||||||||||||||
| from | super | to | extra | or | average). |
|
|
|
|
|
|
|
|
|
|
|
|
|
|