Sunbeam 2585 manual What To Check, What To Do, Troubleshooting Check List

Figure 17

NOTE: An occasional “arcing” sound is normal when operating the unit immediately after cleaning the cell and should stop after a few minutes of operation.

TROUBLESHOOTING CHECK LIST

Many times service problems that appear to be major can be	solved quite easily. The chart below lists potential problems
and how to correct them. Remember, check the simple things	first.

	CONDITION			WHAT TO CHECK					WHAT TO DO
	Unit fails			1. Power cord				1. Plug in	power	cord.
	to turn on.			2. On/Off	Switch			2. Set On/Off switch for desired blower speed.
				3. Cabinet Top is properly				3. Refer to Item D, Page 4.
				installed.
				4. Cell is properly installed.				4. To properly install the cell, make sure the
								side of the cell with three notches at the
								bottom is located next to the switch.
	Unit does		not	Setting of On/Off switch				Set On/Off switch on High. Run unit for one
	operate	at	Low speed.					minute and reset On/Off switch at Low speed.
	Unit does		not	Ionizer-Collector		Cell		Wash ionizer-collector cell by following the
	remove	pollutants.						directions listed in “To Clean Cell”. Operate unit
								for one week, remove the cell and look at the
								cell. If operating correctly, the cell will have a
								collection of “adhered pollutants” attached to
								the plates of the cell.
	Unit sparks,			Ionizer-Collector		Cell		Wash ionizer-collector cell. Make sure cell is
	crackles and pops.							thoroughly dry.
	Unit still does not			Re-check the above points				Have unit serviced.
	operate	properly.
NOTES:
	1. Discoloration of aluminum			collector cell	plates	is normal	with use, even		after	cleaning,

2.Blowing smoke directly into the front grill is not a test for unit performance.

5