Plug electrical cord into 120 volt, 60 cycleAC outlet.
Raise can opener lever to upright position (A). Insert can so that the lower edge of the can lip rests on top of the drive wheel. Be certain that the cutting edge is on the inside of the can lip as shown (B).Push can opener lever down firmly (C) and hold until the can lid is automatically pierced and the cutting action begins. It is not necessary to hold the can opener lever down during the cutting cycle.
When the can is fully open, the cutting action will automatically stop. The can will remain in position until the lever is raised. To release the can,
grasp the can firmly in one hand and raise the lever with the other hand. The magnetic lid holder will retain the lid (D).
Dented Cans: Occasionally, badly dented cans will cause the can opener to stall. If this happens, grasp the dented can and guide it through the cutting action manually until the damaged areas are passed.
Jammed Cans: To open a can that has become jammed, raise the can opener lever and release the can. Begin the cutting action again in a new place on the can lip.
C
