Knives:
Plug the electrical cord into a 120 volt, 60 cycle AC outlet.
Press down on the can opener lever to start the grinding wheel. Allow the motor to develop full speed.
Insert the knife into either slot of the sharpening guide, holding it flat against the sloping wall of the housing. Lower the blade until it touches the wheel.
Draw the knife blade towards you (I), keeping the blade against the sloping wall of the housing.Maintain only a slight pressure on the wheel. Repeatthe same operation using the other slot. Alternate the knife blade from slot to slot to sharpen both sides of the blade. Continue this process until the desired sharpness is achieved.
SCiSSOrJ:
Press down on the can opener lever to start the grinding wheel. Allow the motor to develop full speed.
Open scissors, hold blade to be sharpened with the other blade on the bottom. Pull blade through slot from left to right (Jj.
Turn scissors over and repeat with other blade. Use light pressure and continuous motion when sharpening.
Cord Storage:
A cord storage area is located on the bottom of the unit to store excess cord. When the cutting assembly is raised, pull out as much cord as required to reach the outlet.
01995
Sunbeam@is a registeredtrademarkof SunbeamCorporation.All rightsreserved.
