Sunbeam 32863281 Putting In The Coffee, Turning Unit On, Filling The Water Reservoir

USING YOUR COFFEE MAKERÕS CONTROLS

(Basic Units Only)

CustomBlend

On Off

On Switch – This switch turns the coffee maker “ON”.

OFF Switch – This switch turns the coffee maker “OFF”.

PUTTING IN THE COFFEE

Swing the filter basket door outward to your right. Insert a standard flat paper filter into the filter basket. Place the desired amount of ground coffee into the filter. Use 1 tablespoon of grounds per cup (5 oz.) of water. One coffee scoop equals 2 tablespoons. After using your coffee maker several times,

the amount of coffee may be adjusted to suit your particular taste, by decreasing or increasing the amount of coffee used. Be sure to use coffee grounds prepared specifically for automatic drip coffee makers.

Swing the door closed and snap into place.

FILLING THE WATER RESERVOIR

Open the hinged water reservoir cover located at the top of the coffee maker. Fill the glass carafe with the desired amount of cold water. Empty the water from the carafe into the water reservoir.

POUR SLOWLY WHEN CARAFE IS FULL. Close the hinged lid. Place the glass carafe with the lid in place on the warming plate. NOTE: The amount of brewed coffee after the brewing process will always be slightly less than the amount of water placed into the coffee maker, since some water is absorbed by the coffee grounds and filter. Add a little extra water at the beginning so that you have the exact number of cups desired.

CAUTION: Do not operate your coffee maker if the door does not close completely. If the door does not close completely, check to see that the filter basket is properly sealed, and snap door into place.

Select the desired strength of coffee from mild to strong by turning the CustomBlend™ Knob on the top of the unit.

TURNING UNIT ON

Turn switch “ON” to start the brew cycle. “ON” Light will go on, indicating that the coffee maker has begun the brewing cycle. In a few minutes the coffee maker will complete the brewing cycle and switch over to the warming mode.

The clock must be set before the unit is operational. On models with the Auto-off feature, the unit will turn itself off after 2 hours. To continue heating the coffee simply turn the unit “OFF” and back “ON” again for another 2 hours of heating.

Turn switch to “OFF” when the carafe is empty or when the coffee maker is not in use.

RobustMild

CustomBlend™

7