Using your Pro Glide® 8300 Steam Generator (continued)
Using your iron
1.Insert the plug into a 230/240 volt power outlet and turn the power on.
2.Select the power button to turn the unit on. The Power On light illuminates RED as shown in Fig 1. The boiler and soleplate will begin heating and the low steam selection light flashes BLUE.
Figure 1
NOTE: The default steam rate setting is Low Steam which will flash BLUE when the unit is first turned on.
3.Turn the temperature dial on the iron to the desired setting. The thermostat light (as shown in Fig 2) will illuminate RED to indicate that the iron is heating. It will go out once the iron has reached the selected temperature.
NOTE: When changing the temperature of the soleplate from a higher to lower setting, ensure the iron temperature is stable at the new setting by allowing the thermostat to cycle once (the thermostat light will turn on/off once).
4.Select the desired steam level by pressing the low, medium or high steam rate button (as shown in
Fig 3). The steam selection indicator will flash BLUE whilst the boiler is heating. When the steam selection remains illuminated BLUE and does not flash, the unit is ready to use.
Figure 3
Before using the steam generator on a garment, direct a shot of steam into the air to release any remaining condensation.
5.Press and hold the steam release trigger to iron with steam. To dry iron, do not press the steam release trigger.
NOTE: Both the steam selection indicator and the thermostat light will cycle on and off during ironing as the ironing system maintains the selected steam pressure and temperature levels.
Figure 2
8
