Care and Cleaning (continued)
Figure 7
5.Remove the boiler cap completely. See fig 7
6.Place the unit on its side and carefully pour the descaling solution into the boiler. Replace the cap.
7.Return the unit to the upright position and leave for 2 minutes.
8.Shake the unit back and forth to dislodge any scale build up on the base of the boiler. Leave for 10 minutes.
9.Shake the unit again to swirl the solution around inside the boiler.
10.Place the unit on a sink or vessel so that water can be expelled from the boiler flush cap.
11.Carefully remove the boiler cap and allow the descaling solution to empty.
12.Rinse with 1 cup (250ml) clean water, shake and empty. Repeat.
13.Once you have completed the descaling process, and refilled the tank, the Calc Clean reminder will no longer
be illuminated. The power light will
illuminate and the unit will begin heating as normal.
Note: Sunbeam Steam Ironing System descaling tablets are available from selected department stores and electrical retailers.
12
Calc Clean instructions – using lemon juice Alternatively, if you do not have Sunbeam Ironing System Descaling Tablets, you can use lemon juice to remove the scale build up from inside the unit’s boiler.
1.To flush the boiler, turn the unit off and wait for it to cool completely (approx 2 hours).
2.Place the unit on a waterproof surface, or on the edge of the sink.
3.Slowly release the boiler cap to release
any remaining steam. Remove the boiler cap completely
CAUTION: if the unit has been used prior to cleaning the boiler cap will be very hot. Ensure that the unit has cooled completely before commencing the Calc cleaning process.
4.Empty any remaining water from the boiler.
5.In a small jug, add 1tbs lemon juice to 1 cup (250ml) of water and stir to mix.
6.Place the unit on its side and carefully pour the lemon solution into the boiler. Replace the cap.
7.Return the unit to the upright position and leave for 2 minutes.
8.Shake the unit back and forth to dislodge any scale build up on the base of the boiler. Leave for 10 minutes.
9.Shake the unit again to swirl the solution around inside the boiler.
10.Place the unit on a sink or vessel so that solution can be expelled from the boiler flush cap.
11.Carefully remove the boiler cap and allow the solution to empty.
12.Rinse with 1 cup (250ml) clean water, shake and empty. Repeat.
13.Once you have completed the descaling process, and refilled the tank, the Calc Clean reminder will no longer
be illuminated. The power light will illuminate and the unit will begin heating as normal.
