Sunbeam Electric Heater Heated Blanket and Mattress Pad Set Up, result from a loose connection

Heated Blanket and Mattress Pad Set Up

1Place the heated blanket/mattress pad on the bed with the label at the foot of the bed facing upward.

2Make sure the cord is connected into the module at the bottom of the heated blanket/mattress pad until the plastic hinges click into place.

CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire could	2
result from a loose connection.

3Run the control cord on the floor under the bed. Do not sandwich cord between the mattress and box spring. Avoid any tangling or pinching.

4Control Placement:

• Dual Control for heated blanket or mattress pad –

place primary control (label on back of control) on the right side of the bed.

	Secondary
	Control
Mattress Pad 2	Left Side
Cord Connector	Right Side
	Module
	1
run cord
under the bed 3
Flag Tag	Label

5 Power Cord

Primary

Control

4

•Single Control for heated blanket or mattress pad – the control can be placed on either side of the bed.

			5	Power
				Cord
				4
		Left Side
		Right Side		Primary
				Control
	Module	1	See Control Features on page 4
	2	Label
Blanket Cord Connector			for your individual control.
	Flag Tag	run cord	If there is a flashing light or
		under the bed 3
			your control displays a flashing
5 Plug power cord into a 110-120 volt wall outlet.			“FF”, see page 8.
IMPORTANT	CAUTION: Do not plug main power cord into the wall outlet until you have completely
	set up your warming product per the instructions.
	• Disconnect power cord from wall before detaching control from warming product.
	• Always make sure cords are NOT trapped or pinched between bed slats, mattress,

springs, against wall, foot board or bed frame, or between furniture, walls or chairs. CAUTION: Do not attempt to force the plug. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an outlet. If the plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.

For questions or support, please visit: www.sunbeam.com