Sunbeam Electric Heater manual Warming Throw Set Up, Control Features

Warming Throw Set Up

When setting up your warming throw, be sure to follow the steps below in order.

1 Locate the warming throw’s information label near the module.

2 Make sure the cord is connected into the module at the bottom of the
			2
warming throw until the plastic hinges click into place.
CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire could result
from a loose connection.
	3	Flag Tag

Control

Power

Cord

1

Label

2 Module

Throw Cord

Connector

If there is a flashing light on your control, see page 8.

Throw Cord

3Plug the warming throw power cord into a 110-120 volt wall outlet.

IMPORTANT	CAUTION: Do not plug main power cord into the wall outlet until you have completely
	set up your warming product per the instructions.
	• Disconnect power cord from wall before detaching control from warming product.
	• Always make sure cords are NOT trapped or pinched between bed slats, mattress,

springs, against wall, foot board or bed frame, or between furniture, walls or chairs. CAUTION: Do not attempt to force the plug. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an outlet. If the plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.

Control Features

SlimStyle™ AO (Auto-Off)

A85AP

SlimStyle™

A85P

Using Your Warming Throw Control:

1To turn the throw on simply press the round gray button. The indicator light will glow, depending on which setting the warming throw is set, and the warming throw will begin to warm.

CAUTION: ALWAYS turn the warming throw “OFF” and disconnect the power cord from the outlet when not in use.

2To turn the warming throw OFF simply press the round gray button through the different settings until the temperature setting lights are not glowing.

Features:

•3 TEMPERATURE SETTINGS – select your personal comfort level

•SILENT OPERATION – no clicking when adjusting the temperature

•SOLID STATE – for accurate and consistent heat control

•EASY OPERATION – electronic control for easy operation

•EASY GRIP – ergonomic control for easy operation

•AUTO-OFF (SlimStyle AO only) – 3 hour Auto-Off (see page 2)

For questions or support, please visit: www.sunbeam.com