Sunbeam FT Problem, Possible Cause, Solution, Troubleshooting Your Mr. Coffee Coffeemaker

Models: FT

1 22
Download 22 pages 41.68 Kb
Page 10
Image 10
TROUBLESHOOTING YOUR MR. COFFEE® COFFEEMAKER

15-0906-797_FT_InstrMan_v5.qx 12/1/06 10:22 AM Page 18

TROUBLESHOOTING YOUR MR. COFFEE® COFFEEMAKER

Your MR. COFFEE® Coffeemaker has been carefully designed to give you many years of trouble-free service. In the unlikely event that your new coffeemaker does not operate satisfactorily, please review the following potential problems and try the steps recommended BEFORE you call an Authorized Sunbeam Service Center.

PROBLEM

POSSIBLE CAUSE

SOLUTION

 

 

 

THE “BREW NOW”/ON

• The appliance is unplugged.

• PLUG UNIT IN.

LIGHT DOES NOT LIGHT UP

• There’s a power outage.

• WAIT FOR POWER TO

 

 

BE RESTORED.

 

 

 

THE COFFEE IS

• The appliance is unplugged.

• PLUG UNIT IN.

NOT BREWING

• There’s a power outage.

• WAIT FOR POWER TO

 

 

BE RESTORED.

 

• The water reservoir is empty.

• CHECK THE WATER

 

 

WINDOWS.

 

• The filter basket is not

• INSERT FILTER BASKET

 

properly inserted.

CORRECTLY.

 

• The decanter is not

• PLACE DECANTER

 

placed all the way on

CORRECTLY ON

 

the warmer plate.

WARMER PLATE.

 

 

 

THE COFFEEMAKER

• There are no coffee grounds

• ADD THE DESIRED

ONLY BREWS WATER

in the filter basket.

AMOUNT OF COFFEE

 

 

TO THE FILTER.

 

 

 

THE COFFEEMAKER

• The coffeemaker needs cleaning.

• CLEAN COFFEEMAKER

BREWS SLOWLY

 

AS DESCRIBED IN

 

 

“CLEANING AND

 

 

MAINTAINING” SECTION.

 

 

 

THE FILTER BASKET

• The filter basket is not

• INSERT FILTER BASKET

OVERFLOWS

properly inserted.

CORRECTLY.

 

• The decanter is not

• PLACE DECANTER

 

placed all the way on

CORRECTLY ON

 

the warmer plate.

WARMER PLATE.

 

• The decanter lid is

• PLACE LID ON THE

 

not on decanter.

DECANTER.

 

• Too many coffee grounds

• REMOVE FILTER DISCARD

 

were placed in the filter.

GROUNDS. IF PAPER

 

 

FILTER, REPLACE. IF

 

 

PERMANENT FILTER,

 

 

RINSE. BEGIN BREWING

 

 

PROCESS AGAIN.

 

• The decanter was removed from

• TURN OFF AND UNPLUG

 

the warmer plate for more than

THE UNIT. ALLOW TO

 

30 seconds.

COOL. WIPE UP THE

 

 

SPILL. DO NOT SET HOT

 

 

DECANTER BACK ON THE

 

 

WET WARMER PLATE OR

 

 

IT MIGHT CRACK.

TROUBLESHOOTING YOUR MR. COFFEE® COFFEEMAKER

PROBLEM

POSSIBLE CAUSE

SOLUTION

 

 

 

THE COFFEE IS NOT HOT

• There’s a power outage.

• WAIT FOR POWER TO

 

 

BE RESTORED.

 

• Auto SHUT-OFF has been activated. • FOR BEST RESULTS,

 

 

BREW A FRESH POT OF

 

 

COFFEE.

 

 

 

THE COFFEE TASTES BAD

• Coffee grounds other than

• USE COFFEE GROUNDS

 

for an automatic drip coffeemaker

RECOMMENDED FOR

 

were used.

AUTOMATIC DRIP

 

 

COFFEEMAKERS.

 

• The ground coffee-to-water ratio

• USE CORRECT GROUND

 

was unbalanced.

COFFEE-TO-WATER

 

 

RATIO.

 

• The coffeemaker needs cleaning.

• CLEAN COFFEEMAKER

 

 

AS DESCRIBED IN

 

 

“MAINTAINING YOUR

 

 

COFFEEMAKER”

 

 

SECTION.

 

 

 

THE GROUNDS ARE IN

• The filter is not properly seated

• SEAT FILTER PROPERLY

THE COFFEE

in the basket.

WITHIN THE FILTER

 

 

BASKET.

 

• The filter collapsed.

• REMOVE FILTER AND

 

 

REPLACE.

 

 

 

Do you still have questions? You can call us toll-free at the MR. COFFEE® Consumer Service Department, 1-800-MR COFFEE (1-800-672-6333)or you can visit us at

www.mrcoffee.com.

18

19

Page 10
Image 10
Sunbeam FT user manual Problem, Possible Cause, Solution, Troubleshooting Your Mr. Coffee Coffeemaker