Using your Esteem Travel.
Before using your hairdryer
Squeeze excess moisture from your hair and towel dry. Comb hair free of all tangles with a wide tooth comb.
To operate your hairdryer
1.Fold the handle down away from the barrel until it is in position.
2.Use a small coin to select the appropriate setting on the voltage switch for the local supply voltage either 230/240V or 100/110V.
3.Insert the 2 pin plug into a power outlet and turn the power ON.
To dry your hair
1.Select the desired heat/speed setting - 2 for fast drying or 1 for controlled styling.
2.Hold the hairdryer about 30cm away from your hair to avoid burning your hair. Direct the airflow towards your hair until it is dry.
Use the concentrator attachment to direct air flow onto specific areas of hair for spot drying or when styling.
Care and Cleaning.
Always turn your hairdryer off at the power outlet after use. Turn the power off and remove the plug before cleaning.
Do not immerse your hairdryer in water or any other liquid.
To clean the exterior, simply wipe over with a dampened cloth and wipe dry.
Do not wind the power cord around the hairdryer, as this may cause strain and damage the wiring.
Sunbeam is a registered trademark. Esteem is a registered trademark. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this booklet. Approved by the appropriate Electrical Regulatory Authorities. Backed by Sunbeam‘s 2 Year Replacement Guarantee and National Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2001. (INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on any Sunbeam products, contact the Sunbeam Consumer Service Line on 1800 025 059 in Australia. In New Zealand - contact the Sunbeam Office in Auckland on 09 912 0747.
