Care and maintenance
Cleaning the transmitter
CAUTION! | Water can damage the electronics of | |
the transmitter! | ||
| ||
| Water entering the housing of the transmitter | |
| can cause a | |
| electronics. |
Only use a slightly damp cloth to clean the transmitter.
Before cleaning, disconnect the transmitter from the mains.
If necessary, you can clean the transmitter with a slightly damp cloth. Do not use any cleansing agents or solvents.
Replacing the fuse
WARNING! Electric shock hazard!
In case of improper handling, you may come into contact with electrically conducting parts and receive an electric shock when removing the fuse holder.
Before removing the fuse holder, pull out the mains connector from the wall socket.
Disconnect the transmitter completely from the mains by pulling out the mains connector from the wall socket.
Use a screwdriver to loosen the fuse holder .
Remove the fuse holder with the inserted fuse.
Replace the fuse by a new fuse with the same rating.
Reinsert the fuse holder. Make sure to insert the fuse holder the correct way round.
The set voltage is shown at the top of the fuse holder.
Reconnect the transmitter to the mains and and switch it on again.
23
