Wall mounting your heater (continued)
3.Mark the first top screw location on the wall, at least 630mm from the floor or skirting board. The base of the heater must be at least 200mm from the floor to ensure adequate air flow into the air inlet. Drill the first hole using a suitable drill bit.
4.Measure and mark the second drill hole, 564mm from the first hole. Drill the hole.
5.Measure and mark the bottom screw holes, 289mm below the top two holes. Drill.
6.Position the bracket over the drill holes and screw into position.
7.To place the heater on the bracket, insert the lower clips first then the top, and push firmly until it clicks into position, as shown in figure 5.
Figure 5
Attaching the wheels
Before attaching the wheels, remove the wall mounting bracket from the rear of the heater by pushing down on the top clips and pulling towards you.
1.Position the wheel assembly over the base of the heater, with the vertical bracket to the rear of the unit, as shown in Figure 6.
2.Align the screw hole in the vertical bracket
(C) with the screw hole in the rear of the heater. Place the washer on the screw, insert the screw and fix loosely. Do not tighten.
3.Align the screw holes on the underside of the wheel assembly (A and B) with the holes on the base of the heater. Insert each screw and washer and tighten.
Figure 6
A |
B |
C |
Once all screws are correctly positioned, tighten the screw in position C.
4. Repeat on the other side.
7
