Using your Eco Jet
Before first use
Remove any packaging or marketing materials that may be attached to the Eco Jet.
Partially fill and then empty the water tank to remove any foreign particles that may remain in the tank following the manufacturing process.
Note: When turned on for the first time, your new Eco Jet may drip a small amount of water when initially producing steam. This is normal and will not reoccur.
Filling the Eco Jet with water
Before filling with water, ensure that the power cord is removed from the power outlet.
1.Position the unit on a stable surface and remove the water tank cap.
2.Slowly fill with 300ml of clean tap water using the jug and funnel provided. Measure using the 150ml mark on the side of the measuring jug. Repeat.
3.Replace the cap and tighten.
Note: Do not exceed the maximum water level (300ml) as the unit may fail to operate effectively. The tank may overflow and boiling water may be emitted from the nozzle instead of steam.
Using the Eco Jet
Ensure the unit is unplugged from the power outlet before fitting or changing attachments.
1.Fit the desired attachment following the instructions on page 9.
2.Insert the plug into a 230/240V power outlet and turn the power on. The light near the base of the unit will illuminate, indicating that the steam boiler is heating. Once the light goes out (approx. 3 - 4 minutes), the Eco Jet has reached the optimum temperature for producing steam and is ready to use.
3.Direct the Eco Jet at the desired surface and depress the steam trigger on the handle.
4.Slowly move the Eco Jet back and forth over the surface to be cleaned. To remove stubborn stains, hold the unit over the area for several seconds.
5.Once you have finished cleaning the desired area remove the plug from the power outlet.
6.Allow the unit to cool completely before storing.
Caution: Do not tilt the Eco Jet more than 45 degrees from the horizontal or turn it upside down during or immediately after use. Boiling water could come out of the nozzle instead of steam.
Filling the Eco Jet during use
Do not unscrew the water tank cap until the following steps have been followed.
1.Unplug the power cord form the outlet.
2.Remove any remaining steam from the water tank by depressing the steam trigger until the tank is completely empty.
3.Partially unscrew the water tank cap, waiting five minutes for any remaining steam to escape and to allow the unit to cool down. Proceed to completely unscrew the cap.
4.Carefully empty any remaining water from the water tank.
Caution: Water will be extermely hot.
Note: Always ensure that the water tank is completely empty before refilling the Eco Jet to avoid overfilling. Do not exceed the maximum water level.
5.Slowly refill with 300ml (max) of clean tap water using the jug and funnel provided. Measure using the 150ml mark on the side of the measuring jug. Repeat.
6.Replace the cap and tighten.
8
