Sunbeam Bedding HE3900 manual HE3100 - 1200W heater with micathermic elements

Using your Convection Plus Heater

HE3100 – 1200W heater with micathermic elements

1.Place the heater on a flat level surface and ensure that the air intake and outlet are clear of obstructions.

Note: When turned on for the first time, your new heater will emit a slight odour for up to 8 hours. This is due to the initial heating of the materials used. It is safe, not detrimental to the performance of the heater and will not reoccur. Sunbeam advises that the heater be placed in a well ventilated area during this period.

2.Ensure that the mode dial and thermostat dial are both in the OFF position.

3.Insert the plug into a 230/240V power outlet and turn the power on. The power ON light will illuminate.

4.Move the mode dial to your desired heat setting, either low heat (1) or high heat

(2).

5.Turn the thermostat dial clockwise until the red thermostat indicator light turns on, indicating that the heater is warming to the selected temperature. This light will go out when the selected temperature level is reached.

6.The thermostat is now set and will automatically maintain the pre-set temperature level by turning the heater on and off.

7.To adjust the selected temperature level, rotate the thermostat dial anti-clockwise to lower or clockwise to raise the temperature.

8.To turn the heater off, move the mode dial to the OFF position.

8