Using your Convection Plus Heater continued
HE3900 – 2200W heater with micathermic elements and remote control
1.Place the heater on a flat level surface and ensure that the air intake and outlet are clear of obstructions.
(Refer to Note on Page 8).
2.Ensure that the ON/OFF switch is in the OFF position.
3.Insert the plug into a 230/240V power outlet and turn the power on. Move the ON/OFF switch (located on the side of the heater) to the ON position. The ON/OFF switch will then illuminate.
The LCD screen will display the ambient room temperature.
Note: When the heater is switched on it will be automatically set to the standby mode.
4.Press the mode button to select your desired operating mode. Each time you press the mode button, it will scroll through the various settings as follows:
STANDBY | the heater remains inactive | |
when in this mode | ||
LO | the heater will continuously run | |
at approximately 800 watts | ||
| ||
HI | the heater will continuously run | |
at approximately 2200 watts | ||
| ||
AUTO | for operating the digital | |
thermostat | ||
|
5.To turn the heater off, move the ON/OFF switch to the OFF position.
Using the remote control
The remote control allows you to conveniently operate the heater from anywhere in the room.
The buttons on the remote control are identical to the buttons on the heater. When using your remote control simply follow the normal operation instructions outlined on pages 9 and 10 in addition to the points below.
1.Ensure that the remote control contains 2 x AAA batteries.
2.Point the remote towards the infrared receiver on the heater (located below the plus/minus arrows). Ensure that there are no objects blocking the path between the remote and the infrared receiver.
3.Follow steps 1 to 4 on the left column of this page.
Note: The maximum transmission distance between the heater and remote is approximately 30 metres.
Setting the digital thermostat
The digital thermostat allows you to set your desired temperature for the room. The heater will then cycle on and off to maintain it.
1.Follow steps 1 to 3 on the left column of this page.
2.Press the mode button until the AUTO mode is displayed. Once in AUTO mode, the LED screen will flash your previous
5 seconds the LED screen will display the ambient room temperature.
9
